(see also: Paths Overview)
- Select the Apply Length and Angle tool.
- The Apply Length and Angle tab appears in DesignCentral.
- Do one of the following:
-
Enter the Apply Length and Apply Angle values in DesignCentral.
-
Hold Ctrl and click the segment from where the angle and length will be copied.
-
| Apply Length | Check this field to apply the length to the segment. |
| Apply Angle | Check this field to apply the angle to the segment. |
| Segment Length | Specifies the length to be applied to the segment. Click the dropdown arrow on right to select from a set of predefined factors. |
| Segment Angle | Specifies the angle to be applied to the segment. Click the dropdown arrow on the right to select from a set of predefined angles or the opposite angle. |
- Click the cursor on the segment where the angle and length will be applied.
Press Shift to change the point on the segment that is used as the reference.
| Acquiring the length and angle | Click to apply the length and angle. | Shift + click to apply the length and angle. |
| Ctrl+Click | Click | Shift+Click |