Change Start Point

(see also: Paths Overview)

Every path has a starting point. When a path is cut, the plotter will start cutting from the starting point. In an open path, the starting point must be at one end of the path.

  • Use the Select Tool mceclip0.png to select a path, or the Select Point Tool to select a point or segment.
  • Select the Change Start Point mceclip1.png tool.
  • Click and drag the starting point to its new position.
  • Hold Shift and drag to move the starting point to an existing point.
  • Click Apply or double-click anywhere inside the design area.

Note: you can also view the Path Direction of the path as well for the purposes of your plotter.

See: Path Direction

Was this article helpful?
0 out of 0 found this helpful