Create a series of lines and arcs to form a new contour.
Create segments one at a time using the drawing modes to modify each segment individually.
-
Activate the Polyarc command to automatically open the precision toolbar
-
Select line or arc mode in the precision toolbar
-
Select creation mode based on the desired drawing mode
Creation Mode options will only be available when available based on the arc or line creation mode. Arc creation modes cannot be used when drawing a line.
This tool can only be used in the top view. Arcs are limited in EnRoute to the X-Y plane.
Creation Modes
| Line | Toggles line segment creation mode |
| Arc | Toggles arc segment creation mode |
| Position | Define the X Y coordinates for the next point in the segment |
| Direction | Define the angle for a line being created. Define the angle of the tangent line for an arc being created. |
Only available in arc mode:
| Arc Center | Define the arc center |
| Radius | Define the arc radius |
| Sweep Angle | Define the arc sweep angle |