Adjust where start points are automatically located for routing offset toolpaths
| Long Edge | Locate the start point at the start of the longest edge of the contour. If Edge Midpoint is checked, the start point will be placed at the midpoint of the longest segment. |
| Direction | Define a direction used to locate the starting point. The direction is defined in degrees relative to the drawing origin. |
| Magnetic | Enter a specific point and the start points will automatically be placed as close to the defined point as possible. |
| Longest Segment | Locate the start point at the start of the longest segment of the contour. If Segment Midpoint is checked, the start point will be placed at the midpoint of the longest segment. |